This was done on a Windows XP servicepack 2 system, I have no access to a Vista system Below is the readme.txt file with the additions I made (at the bottom) - 1) Install Mastercam X4, select Sim Type >NetHASP 2) Run 'mastercam_x4_nethasp_crk.exe', browse to click Start >OK 3) If you have got Mastercam X3 installed as Sim Type >Download Beamng Drive Keygen Download there. I went and tried some different combinations as the problem obviously had to do with the HASP drivers. I try to seach that file can't find, any one can help. It will typically be found in the system or system32 folder. Search and delete the following file XHasp.sys.Search registry and delete any XHasp entries.Everything listed under X,X2 as well as items listed below.There’s a chance that some of these will need to be deleted too in order to completely eliminate the error but start off with the first two steps. The attached file Emulaotr.txt contains additional entries emulator may install.Start by looking in the Registry (in both HKEY_LOCAL_MACHINE & HKEY_CURRENT_USER) for SystemCurrentControlSetServicesEmulatorHASP and delete it. If you still receive the same error when trying to start the software then you will need to clean the registry of any indications of the HASP Emulator.
First search the entire hard drive for the following file.Hasp95.vxd & Hasp95DL.vxd These will be found in either the windows/system or windows system32 folder depending on the operating system. Question/Issue_ (Sim) Error message: Invalid SIM found-error code 2, EXE not valid Cause: Hasp emulator Answer/solution_ V9
0 kommentar(er)
